Flickermaster SPE-6 Description Random flashing control unit with a maximum capacity of 2000 watts incandescent load. Use as a dimmer, a random flicker device, or a strobing effect. High and low ends of the flicker range can be controlled separately, as can the speed of the flicker or strobe.

Flickermaster SPE-6 Specifications Housing is constructed of 14 gauge aluminum with a black painted powder coat finish and built in carry handle. All knobs and input connections are recessed for safety. There are four knob controllers with white position pointer lines for the following functions: SELECT-off/dimmer/flicker/strobe, speed-varies rate for flicker/strobe, LOW LEVEL-to trim bottom output of flicker/strobe, and DIMMER-to adjust output from 100% to 0% of voltage using a smooth square law dimmer curve. Solid state dimmer electronics are fully filtered to minimize lamp noise. Front panel has remote female jack receptacle to connect optional remote control which can be either a simple closure switch or a 0 to 10 volt DC signal. Two LED indicator displays for POWER and STATUS. Fuse is rear panel accessible. Power in/out pigtails are 8 inch long #12/SJO wire with machined aluminum strain relief housings. Unit rests on 1/2in. high by 1in. diameter molded rubber legs, as manufactured by GAMPRODUCTS Inc., Hollywood CA.

Flickermaster SPE-6 Technical Data

Size(unit)
Width: 9in. (23cm)
Height: 3-3/4in. (9.5cm)
Depth: 10-5/8in. (27cm)

Weight(frame)
Unit 7.25lb. (3.24kg)

Housing
4 gauge aluminum

Finish
Black powder coat, with white silk screened face panel for recessed control knobs.

Power
120VAC @ 20 amps or 230VAC @ 10 amps

Connector
3 wire 8in. pigtails terminating in either 3 pin stage connector orEdison U ground
230V model terminate in bare wire.

Cable
#12SJO with strain relief

Model #
SPE - 6
SPE - 6/R rack mount, see separate data sheet

Specifications subject to change without notice