- DMX or Manual Control
- Available in 120 volt or 220 Volt Models
- Rugged Aluminum Case with Carry Handle
- Recessed Control Panels to Protect Knobs
and Circuit Breaker
- Up to 2000 Watt Capacity
For Best LED Results:
- Use 120 volt LED fixture or lamp that does not require a transformer or power supply
For Best Fluorescent Results:
- If possible use dimmable ballasts for best results
- Excessive strobing or flickering may shorten lamp life
|
OPERATION INSTRUCTIONS
Apply appropriate power to pigtail. Flickermaster
DMX8© can be supplied with Edison plugs, stage pin,
twist lock connectors or bare wire. The 220V model is
supplied with bare leads - green is ground.
|
REMOTE JACK - Used to turn Flickermaster DMX8©
on and off from a remote location. See remote jack or
DMX instructions on back page.
STATUS (Green/Red LED) - When powered, this light
is red and green when DMX is present. |
SELECT
OFF - Left hand knob in the OFF position, no output
from the Flickermaster DMX8©
DIM - Set left knob to DIM when you wish to use
Flickermaster DMX8©as a dimmer, or when focusing
your lights so that they are not blinking or strobing.
Dimmer knob controls brightness and must be turned
up past zero for light to come on.
FLICKER - Set left knob to this position when a
random flicker is wanted. (SPEED, LOW and DIM
are operational in FLICKER and STROBE mode.)
STROBE - Set left knob to this position for STROBE effect.
SPEED
Use to adjust the rate of flicker or strobe - 0 is slow,
10 is the fastest. Speed setting is operational in
FLICKER or STROBE modes.
LOW LEVEL
Low level control allows for variable compression of
the flicker range to create the very low flickering of gas
lamps or a roaring fire. Functional when Flickermaster
DMX8© is set to FLICKER or STROBE modes.
DIM
Dimmer control - 0 being lowest, 10 the highest.
Functional in all settings except OFF. You may
use the dimmer to compress the high level
of the flicker or to fade out an effect in either
FLICKER or STROBE modes. |
OUTPUT (Red LED) - Indicates level of output.
Flickers to show flicker/strobing range. In DIM setting,
glow intensity is relative to output level.
BACK PANEL
- Power IN / OUT pigtails, 20 amp.
- IN/OUT DMX & Channel Address
The Flickermaster DMX8©can be supplied as either a
120V or 220V model.
Please see page 2 for Remote and DMX Instructions
|