The Loop that is being projected should be installed upside down. Power is applied through the 4-pin XLR connector using the TSPS-20 power supply or TSPS-80 power supply or appropriate power supply.
For use with DMX control; select 1 on Mode Switch. Set
DMX address on Loop Tray to desired control channel.
Channel |
Loop Speed and Motion |
0 |
No Motion |
1 |
Full speed rotation in forward direction |
2 - 39 |
Decreasing rotation speed in forward direction |
40 |
Forward motion stopped |
41 - 59 |
No Motion |
60 |
Slowest motion in backward direction |
61-99 |
Increasing rotation speed in backward direction |
100 |
Full speed rotation in backward direction |
For use with DMX control; loop speed and direction.
Channel |
Controls |
1 |
Loop Speed:
0 = No movement
100 = Full motor speed |
2 |
Loop Direction:
0 - 35 = Forward loop direction
36 - 64 = No movement
65 - 100 = Backward loop direction |